Introduction
How High To Jack Car For Tire Change?
How High To Jack Car For Tire Change? The manufacturer provides a jack for such an emergency, but it is only for raising the vehicle to change the tire in an emergency. Don’t even think about using it for something else! And if you have an alternative, so use a different jack, which is better for the job.
No matter what jack you are using, you should never rely on your life, and go under the vehicle only when the jack is securely standing. You can be seriously injured while working under a car when proper floor jacks are used as the only source of support, OEM spare tire jacks fail or the car is driven at a dangerously high frequency. allow roaming. ,
Also Read:
How High To Jack Car For Tire Change?
Jack up your car safely
Remember Always observe the following precautions when jacking up a your vehicle:
- Park the vehicle on a stable, level ground and block the wheels.
- Put the transmission in park (automatic) or leave it in gear (manual) and set the parking brake (both).
- Locate and remove the jack, lug wrench and spare tire from the car. If they’re not in the trunk, check behind the storage panel in the cargo area or under the back seat. Sometimes they get stored under the hood in front of or under the motor, or even behind the front seat of a pickup truck.
- Never work under a vehicle using a factory spare tire jack.
Changing A Tire
Now that you have all the tools and spare tires, it’s time to get to work.
- Remove the center cap or wheel cover if necessary to expose the lug nuts.
- Loosen the lug nut before lifting the vehicle.
- Locate the appropriate lifting point. On most vehicles, this is a notch in the seam that runs under the rocker panel, or a lifting pad behind the front wheel opening or in front of the rear wheel. If you cannot locate the factory jacking point, check your owner’s manual. Solid-axle rear-drive vehicles are often raised by axles or spring pads on a leaf spring.
- Place the jack under the vehicle and adjust the height by hand until it fits the notch in the rocker panel flange — or touches the lifting pad — that is closest to the wheel to be replaced.
- Insert the handle and operate the jack in slow, smooth motions until the wheel is off the ground. Remember to raise it high enough to fit the inflated spare tire.
- Remove the lug nuts, pull the wheel, install the spare and finger-tighten the lug nuts.
- Tighten them firmly with the wrench in a criss-cross pattern, but wait until the car is down to fully tighten.
- Lower the vehicle and remove the jack.
- Tighten the lug nuts in a criss-cross pattern with a wrench. It’s almost impossible to over-tighten the nuts by hand, but it’s better than loosening them too much.
- If your vehicle is equipped with a small temporary spare tire, remember that it is only for temporary, low-speed use. Unless otherwise marked, do not exceed 50 mph when using temporary parts.
Conclusion
We hope you find our informational article of How High To Jack Car For Tire Change? Check out more article about best tires, car care & more.
